Flow-type magnetic separator MF 50/1-UP-S6-N-4-80-S-P

This separator not suit you?
We will make a custom separator for you
Contact us

Customer support

+1 619 488 1743
info@magneticseparators.us

Make an inquiry

Parameters

Material Stainless steel DIN 1.4301, EN 10088, ČSN 17240, AISI 304, AKV 7 - non-stabilized austenitic nickel-chromium steel (X5CrNi 18-10)
Number of magnetic bars 3
Total weight 35.3 lbs
Magnet temperature resistance 176 °F
Input/output 2.0 in
Body surface finish Glass ball blasting
Sealing Silicone (-58 °F to 302 °F)
Piping connection 2x DN 50 threaded connection; material: 1.4301
Number of casings Single casing
Number of magnetic rods detail 3 (3 x dia. 1.2 in)
Tearing force 93 N
Maximum pressure PS 6 bar
Maximum temperature TS 176 °F
Magnetic component weight 21.6 lbs
Magnetic force 10.200 Gs
Magnetic bar surface finish Polishing, Ra value 0.1 µm
Product state Testing
Design UP
Purchase or lease Terms of lease
Variant        Price per day without VAT Price per day with VAT Savings
Purchase
5 days rental -$3,782.62 -$3,782.62 0 %
10 days rental -$1,641.31 -$1,641.31 56.6 %
20 days rental -$570.66 -$570.66 84.9 %
30 days rental -$214.10 -$214.10 94.3 %
50342.T
8595133923651
Standard price $2,914.75 Discount -$582.95
$2,331.80 $2,154.09

  • -20%

Supplementary letter

The equipment is designed to separate metallic impurities from media that are not hazardous per Article 13 of Directive 2014/68/EU (PED) - Media group 2. These magnetic flow separators do not fall under any category of pressure equipment per 2014/68/EU (Article 4, para. 3). For more information, visit: www.magneticke-separatory.cz (opens in a new window)

For more information, visit:  www.magnetic-separators.info (opens in a new window)

 TEST METHOD

Magnetic Induction Measurement Procedure

The measurement is performed using a standard gauss meter at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The test is repeated 3 times in different locations of the magnetic circuit; then the average magnetic induction is calculated.

Tearing force measurement procedure

This force is measured using a polished steel measurement standard with a diameter of 10 mm and a height of 20 mm. The measurement is performed at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The force at which the standard is separated is recorded. The test is repeated 3 times and then the average tearing force is calculated.

For your information, this value is 10 N = approx. 1 kg.

The resulting tearing force depends on a range of factors, e.g. on the dimensions of the measurement standard, the air gap between the standard and the tested magnetic circuit, the measurement standard's surface finish, etc.

16 of other products in the same category: